Installation

!

CAUTION:

Do not plug the A/C adapters into a 240 VAC outlet because you will damage the adapter and the module. You must first obtain an adapter to convert 240 VAC to 120 VAC.

5.If applicable, administer the line and station ports by using the procedures in the DEFINITY® Communications System Generic 3 Implementation Guide, Issue 1, document #555-230- 655.

If the Switch Module is connected to a DEFINITY ECS analog circuit pack, you should administer the line port for Direct Inward Dialing (DID) operation.

Administer the station port as you would any other on- premise station.

Connections for Data

Transmission

The RS-232 port on the Remote Module can be used for data communications with the RS-232 port on the Switch Module. Your system administrator should provide you with information about the computer connections at the Switch Module. At the Remote Module, you will need to connect your personal computer (PC) or data terminal to the RS-232 port on the Remote Module. A 9-pin straight through cable will work for many PCs. You will need an adapter if your equipment does not have a 9-pin connector. Figure 3-2lists the pin-out for the 9-pin female connector on the back of the Remote Module.

.

Issue 1 June 1998 3-7

Page 62
Image 62
Lucent Technologies 1100 manual Connections for Data Transmission