Lucent Technologies 555-232-102 manual 2. WT Download Error Codes continued, Severity

Procedure: WT Firmware Download and Connection

Table 4-2. WT Download Error Codes (continued)

Error Code	Severity	Description/Recommendation
0x82	Low	WT timed out waiting for the program data from
		the RC.
		For the 9601 WT, restart the download process.
		For the 9630 Series WT, the download
		automatically restarts; therefore, no user
		intervention is required.
0x83	High	Download cable is not connected.
		Connect the download cable between the RC
		and the WT, and restart the download process. If
		the cable is connected and the error continues to
		occur, use another download cable.
0x84	High	Error while programming flash device.
		Restart the download process. If the error
		continues to occur, try a fully charged battery.
0x85XX	High	Flash memory erase error; reason XX.
		Restart the download process. If the error
		continues to occur, try a fully charged battery.
0x86	Low	WT timed out waiting for RC “info” message.
		For the 9601 WT, restart the download process.
		For the 9630 Series WT, the download
		automatically restarts; therefore, no user
		intervention is required.
0x87	High	RC wants to communicate at a bad baud rate.
		Restart the download process.
0x88	High	RC wants to send a file in an unsupported
		format.
		Restart the download process.
0x891	High	The connected RC circuit pack is not enabled or
		assigned as a server and is therefore disabled
		from allowing WT upgrades.
		Check the Feature-Related System Parameters
		form at the bottom of page 2 for the RC circuit
		pack. If the circuit pack is not listed, issue the
		change system feature command and add it to
		the list. Then issue the enable wt-upgrade
		[PPCSS] command.

Issue 5 June 1999 4-13