Lucent Technologies 555-232-102 manual 4. Wireless-Related System Parameters Form G3si/vs/Prologix

Procedure: Software Installation

change system-parameters wireless Page 1 of 1

WIRELESS-RELATED SYSTEM PARAMETERS

System Identification: 0100015-2176

Maximum Radio Controllers:	10	Master	Port Network: 1
Maximum Wireless Terminals:	200	Radio	Transmission: y
		UTAM Disablement? y

Allowable Carrier Frequencies (MHz)
0: 1929.375		y	4: 1924.375		y
1: 1928.125		y	5: 1923.125		y
2:	1926.875	y	6:	1921.875	y
3:	1925.625	y	7:	1920.625	y

Port Networks With Radio Controllers

1:y

2:n

3:n

Figure 2-4. Wireless-Related System Parameters Form (G3si/vs/Prologix™)

7.Allow the administrable part of the System Identification field to remain at the default value of 2176.

NOTE:

This field provides the system with an identifier that is broadcast regularly in its beacon or traffic-bearing channels. The system ID includes two parts: system-generated digits and administrable digits. The system-generated part is displayed as a read-only prefix to the administrable part.

If this field is changed, you must busy out, reset, and release the RC before the change will be read into the RC.

8.In the Maximum Radio Controllers field, enter the maximum number of RCs that may be administered in the system. This number is based on the UTAM clearance for the site from the DWDT, and it should match the number of RCs designated in the DWDT package. UTAM clearance from the DWDT and the DWDT package are required for DWBS activation in the United States. Valid values for the field are from 0 to 50 inclusive.

NOTE:

The field determines the number of RCs that are added to the system via the add radio-controllercommand. The field does not limit the number of RC

Issue 5 June 1999 2-5