Lucent Technologies 555-232-102 manual 3. Typical Terminations and Cross-Connects for WFBs, “A1”

Wireless Fixed Base

4-pair cable routed from
110 hardware located in
	equipment room to
	103 connecting block
		next to WFB.
	(See the following					Transformer (4) Each
“103 Connecting Block”
			figure.)					PHONE		LINE
									OTHER
			103 Conn	e	cting
DW8A-DE			Block				DW8A-SE Cord
	Cord
							103848800 terminates
							all pairs on the 110
							station hardware.

WFB
“A1”
				110AB2-300 Station
From the transformer DW8A					Hardware
cord jumper, connect the W/BR		Four Pairs to WFB
(ground) pair to the W/BL-BL/W
		1A	1B	2A	2B
pair of the 4-pair cable to the						To Firmware
WFB. Also connect the BR/W						103 Jack
(-48V) pair to the W/BR-BR/W		DW8A-SE Cords
pair of the 4-pair cable to the		TX1	TX2	TX3	TX4
WFB. Doubling up the pairs
extends the power from the
power supply to the WFB
to 650 ft.
Place the dual jumper from the
WFB radio card port to the	110AC2-600 Switch Port Hardware
W/O-O/W and W/G-G/W pairs of
the 4-pair cable to the WFB.		WFB Ports
	Radio	1A	1B			Firmware
						Port
	Card “A”
	Radio 2A		2B
	Card “B”
NOTE: See the following
“Cross-Connects
for WFBs” figure.

DW8A-DE Cord

Coiled

Lucent switch tech will install this 103 jack.

Firmware

103 Connecting Block

4-Pair Cable

Place the 3-pair jumper from the firmware port to the 4-pair cable serving jack.

Located Inside Equipment Room

Figure 3-3. Typical Terminations and Cross-Connects for WFBs

Issue 5 June 1999 3-15