Lucent Technologies 555-232-102 manual Field Name Explanation

Switch Administration

Table 2-1. Radio Controller Circuit Pack Form Fields

Field Name	Explanation
RC Location	This field displays the cabinet, carrier, and slot of the TN789 circuit
	pack. No input is required.
WFB A Parameters
Location	Enter the code for WFB A followed by a description of its physical
	location (for example, “3A-1st floor aisle”). The code for WFB A is
	provided on the floor plan.
	This field must be administered if the internal antenna or at least
	one CAU on the WFB is administered as y.
Internal Antenna	Enter n, unless you have an internal antenna via a special order
	from Lucent Technologies.
CAU Conn	Enter y to designate that a particular CAU is connected to the
	WFB. The default is n.
	NOTE: Once the CAU is administered and attached, be sure to
	busy out and release the WFB.
Location	Enter a description of the physical location of the connected CAU
	(for example, “front aisle/hardware”).
	This field must be administered if the associated CAU Conn field is
	set to y.
WFB B Parameters	NOTE: Repeat the previous process for WFB B, if applicable.

22.If the DWBS has 9630 Series WTs, administer them.

Native support is not provided for the 9630 Series WT. Except for the physical handset, the 9630 Series WT is identical to the 9601 and 9601+ WTs. The 9630 Series WT is administered as an alias of either the 9601 WT or 9601+ WT via the Alias Station form.

Whenever you want two call appearances, you should administer the 9630 Series WT to a 9601 WT. Whenever you want three call appearances, you should administer the 9630 Series WT to a 9601+ WT.

To access the Alias Station form, enter the change alias station command. An example of the form appears as follows.

2-12Issue 5 June 1999