FOREWORD
This section must be read carefully before any connection is made to the mains supply.
EQUIPMENT MAINS WORKING SETTING
Your Marantz product has been prepared to comply with the household power and safety requirements that exist in your area.
COPYRIGHT
Recording and playback of some material may require permission. For further information refer to the following:
-Copyright Act 1956
-Dramatic and Musical Performers Act 1958
-Performers Protection Acts 1963 and 1972
-Any subsequent statutory enactments and orders
WARNINGS
•When the projector is mounted on the ceiling, the Ceiling Mount Kit approved by MARANTZ must be used for installation.
•Do not look into the lens when the projector is turned on. It could damage your eyesight.
•Unplug the projector from the wall outlet if it is not to be used for a few days.
•When the switch is in the OFF position, the apparatus is NOT disconnected from the AC supply mains.
•The
Lamp Handling Precautions
DANGER
The
Lamp life also varies according to the lamp with some even breaking or burning out as soon as they are used the first time. If the lamp breaks, glass fragments may be scattered inside the lamp unit and projector, and mercury gas from the bulb may seep from the projector’s vent.
Before use, carefully read the User Guide of the projector and the Lamp Replacement Instructions. Remember to handle the lamp with care. In the event of serious trouble, call for Marantz authorized dealer.
•Never look directly into the lamp with unprotected eyes while lit. The bright light can cause sore eyes and impair vision.
•Never directly expose skin to the light of the lamp. Direct exposure can inflame the skin.
•Do not drop, impact, subject to excessive force or otherwise damage the lamp.
•Replacing the lamp runs the risk of burns and electric shock, therefore shut off power supply, unplug the AC power cable from its electrical outlet and wait at least 60 min for the lamp to cool down before attempting to replace it.
•If the lamp breaks, unplug the AC power cable from its electrical outlet and call for Marantz authorized dealer to replace it. Do not replace the lamp yourself or clean up broken glass inside the projector as this can result in cuts as well as scratching inside the projector.
•If the projector is hung from a ceiling or installed in a high place, it is extremely dangerous to replace the lamp. In this case, do not replace or service the lamp yourself.
CAUTION
•The chance of the lamp breaking is high after extended use. It is recommended to replace the lamp when near the end of its designed life. Do not use a lamp beyond the maximum lighting time.
•Use only Marantz original lamp units. Check the model code of the lamp unit matches that in this User Guide.
•Before replacing the lamp, read carefully “Lamp Unit Replacement” in this User Guide. Replace the lamp as explained therein.
•Entrust disposal of a used lamp to a licensed industrial waste handler or return it to the place of purchase. Do not break the lamp or discard with general waste.
•If the lamp breaks, leave the area immediately and stay away for at least 30 min, and ventilate the room so as not to inhale the mercury vapor.
•If you inhale the mercury vapor, see a physician immediately.
ENGLISH
1
