Marantz Model VP-10S1 manual Rear and Terminals, Bottom, Lamp cover, Securing screw

Rear and Terminals

Terminals

1	2		3			4
VIDEO IN S-VIDEO IN COMPONENTVIDEO IN 1			COMPONENTVIDEO IN 2
	Y	PB/CB PR/CR	Y	PB/CB	PR/CR
				REMOTE		TRIG. LIGHT
RGB IN	DVI-D IN	RS-232C			IN	1
				INT. EXT.		OFF ON
					OUT	2

11 10 9 8 7 6 5

Lamp cover

❖Terminals

zVIDEO IN jack

Connect to the video (composite) output of a video device.

xS-VIDEO IN jack

Connect to the S-video output of a video device.

cCOMPONENT VIDEO IN 1 & 2 jacks

Jacks 1 and 2 have each Y, PB /CB and PR /CR jacks.

Connect to the component video output of a video device, AV amp/processor, DVD player, etc.

vTRIG. 1 (TRIGGER 1) jack

Use to control an external unit from this projector by interlocking the external unit to power ON/OFF (standby) on this projector. The TRIG. 1 jack outputs 0 V when the projector is on standby and 12 V when POWER button is in the on position.

Note:

IR sensor

10

10

Lamp cover 11

securing screw

12

,REMOTE switch (INT. / EXT.)

Set to “EXT.” to control this projector from another connected Marantz product, whereas set to “INT.” to control this projector and other connected products from this projector.

. RS-232C port

This is the control terminal for custom installers.

⁄0DVI-D IN jack

Connect to the RGB digital output of a video device or PC. Note: When using the DVI-D IN jack, operate the projector

as explained in the precautions on pg. 16.

⁄1RGB IN jack

Connect to the RGB output of a video device or PC.

Bottom

ENGLISH

To connect with external devices, use an ordinal 35mm mini- plug (mono) cable with attaching the supplied ferrite core.

bLIGHT ON/OFF switch

Switches the terminal lamps on/off.

nTRIG. 2 (TRIGGER 2) jack

The TRIG. 2 jack outputs 12 V in each aspect ratio mode (Full, Normal, Zoom or Through). For setting instructions, see “Trigger 2” (☞ pg. 33).

Notes:

•Do not use the TRIG. 1 or 2 jack for power supply.

•To connect with external devices, use an ordinal 35mm mini- plug (mono) cable with attaching the supplied ferrite core.

mREMOTE IN / OUT jacks

Use to control this projector when combined with Marantz products into a system. Connect the REMOTE CONTROL OUT of the other Marantz product to the REMOTE CONTROL IN of this projector and the REMOTE CONTROL IN of this other Marantz product to the REMOTE CONTROL OUT of this projector.

Note:

Use the included bus control adapter cable to connect this projector to other Marantz products.

13

!3Screw holes for ceiling mount kit

Use to hang the projector from a ceiling. To hang the projector from a ceiling, contact your nearest Marantz Authorized Dealer or Service Center.

9