Set up speakers | around items indicate the settings. |
Here we describe how to set up speakers other than |
|
For the method of setting up |
|
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
•Changing the amplifier assignment (Pre Assign)
The signal output from the FL/SBL/HL and FR/SBR/HR connectors on PRE OUT of the amplifier can be switched in accordance with the speaker environment (vpage 35 “Set up “Pre Assign””).
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 36 “Set up “Channel Select””).
version Basic
1 | Set up the | 2 | Connect the setup microphone. |
| |||
remote control unit |
| ||
|
|
|
nn Set up the operation mode
Press AMP to set the remote control unit to AMP- operation mode.
| When the setup microphone is | |
| connected, the following screen is | |
| displayed. |
|
| Audyssey Auto Setup | MultEQ |
| Preparation |
|
Press AMP | Connect the speakers and place them according | |
to the recommendations in the manual. | ||
| Next |
|
| [ENTER] Enter | [RETURN] Cancel |
3 Select “Next”, and then press
ENTER.
4 | Set up “Pre Assign” |
Use ui to select “Pre Assign”, and then press
ENTER.
Audyssey Auto Setup | MultEQ |
Preparation
Set the following items if necessary.
Pre Assign
Channel Select
Auto Setup Start
[ENTER] Enter | [RETURN] Cancel |
Pre Assign |
| MultEQ | |
|
|
|
|
Pre Assign | NORMAL |
|
|
|
|
|
|
version Advanced
Information
[RETURN] Return
vSee overleaf
35