System Setup
Setting items | Setting details |
|
|
Channel Level | Test Tone Start : Output test tone. |
Set the volume of the test | • Front L / F.Height L / Center / F.Height R / Front R / Surround R / |
tone to be the same when it S.Back Rz / S.Back Lz / Surround L / Subwoofer : Select the speaker. is output from each speaker. zz When the “Speaker Config.” – “S.Back” setting (vpage 55) is set
to “1spkr”, “S.Back” is displayed.
•
• When “Channel Level” is adjusted, the adjusted values are set for all the surround modes. To adjust the channel level separately for the different surround modes, use the operation see page 40.
•When you press TEST TONE, you can enter this
setting item immediately.
NOTE
•Speakers set to “None” in the “Speaker Config.” (vpage 55) settings are not displayed.
•When a headphones jack is inserted in the PHONES jack of this unit, the “Channel Level” is not displayed.
Default : The “Channel Level” settings are returned to the default settings.
•Yes : Reset to the defaults.
•No : Do not reset to the defaults.
When you select “Default” and press ENTER, the “Return settings to the default?” prompt
is displayed. Select either “Yes” or “No”, and press ENTER.
BD | 57 |
Setting items | Setting details |
|
|
Crossover Freq. | Crossover : Set the crossover frequency. |
Set the maximum frequency • 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
of the bass signal output | 250Hz |
|
| |
from each channel to | Advanced : Specify crossover frequency for each speaker. | |||
the subwoofer. Set the | ||||
• Front / Center / Surround | / S.Back | / F.Height : Select the speaker. | ||
Crossover Frequency to | ||||
• 40Hz / 60Hz / 80Hz / 90Hz | / 100Hz | / 110Hz / 120Hz / 150Hz / 200Hz / | ||
suit the bass reproduction | ||||
capability of the speaker | 250Hz : Set the crossover frequency. | ||
|
|
| |
being used. |
|
|
|
| • “Crossover Freq.” can be set when the “Bass Setting” – “Subwoofer | ||
| Mode” (vpage 56) setting is “LFE+Main”, or when you have a | ||
| speaker that is set to “Small”. | ||
| • Always set the crossover frequency to “80Hz”. When using small | ||
| speakers, however, we recommend setting the crossover frequency to | ||
| a higher frequency. | ||
| • For speakers set to “Small”, sound below the crossover frequency | ||
| is cut from the sound output. The cut bass sound is output from the | ||
| subwoofer or front speakers. | ||
| • The speakers that can be set when “Advanced” is selected differ | ||
| depending on to the “Subwoofer Mode” setting (vpage 56). | ||
| • When “LFE” is selected, speakers set to “Small” at “Speaker Config.” | ||
| can be set. If the speakers are set to “Large”, “Full Band” is displayed | ||
| and the setting cannot be made. | ||
| • If set to “LFE+Main”, this setting can be made regardless of the | ||
| speaker size. | ||
| vSee overleaf | ||
|
|
|
|
version Basic
version Advanced
Information