Tone
Adjust the tonal quality of the sound.
Setting items | Setting details |
|
|
Tone Control | ON : Allow tone adjustment (bass, treble). |
Set the tone control function OFF : Playback without tone adjustment. | |
to ON and OFF. | “Tone Control” can be set when “Dynamic EQ®” (vpage 51) is |
| |
| set to “OFF”. |
NOTE
The tone cannot be adjusted in the “DIRECT” mode.
Bass | ||
Adjust low frequency range | “Bass” can be set when “Tone Control” is set to “ON”. | |
(bass). | ||
| ||
Treble | ||
Adjust high frequency range |
|
(treble). | “Treble” can be set when “Tone Control” is set to “ON”. |
|
| Audio Adjust |
Audyssey Settings | Default settings are underlined. |
Set Audyssey MultEQ®, Audyssey Dynamic EQ® and Audyssey Dynamic Volume®. These can be selected after Audyssey® Auto Setup has been performed. For additional information on Audyssey technology, please see page 85.
NOTE
•If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup, you may not be able to select Dynamic EQ®/Dynamic Volume®.
In this case, either perform Audyssey® Auto Setup over again or perform “Restore” (vpage 17) to return to the settings after Audyssey® Auto Setup was run.
•When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the “Audyssey Settings” cannot be set.
Setting items | Setting details | ||||
|
|
|
|
|
|
MultEQ® | Audyssey : Optimize the frequency response of all speakers. | ||||
MultEQ® corrects both time | Audyssey Byp.L/R : Optimize frequency response of speakers except | ||||
and frequency response | front L and R speakers. | ||||
problems in the listening | Audyssey Flat : Optimize frequency response of all speakers to flat | ||||
area based on Audyssey® | response. | ||||
Auto Setup calibration. We | Manual : Apply frequency response set with “Manual EQ” (vpage 52). | ||||
recommend “Audyssey”. | OFF : Turn “MultEQ®” equalizer off. | ||||
MultEQ® is the prerequisite |
|
|
|
|
|
function for Dynamic EQ® | • “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be selected | ||||
and Dynamic Volume®. | |||||
| after Audyssey® Auto Setup has been performed. “Audyssey” is | ||||
| automatically selected after performing Audyssey® Auto Setup. When | ||||
| “Audyssey”, “Audyssey Byp. L/R” or “Audyssey Flat” is selected, |
|
|
|
|
| illuminates. |
|
|
|
|
|
|
|
|
| |
| • After running Audyssey® Auto Setup, if the Speaker Configuration, | ||||
| Distance, Channel Level, and Crossover Frequency have changed | ||||
| without increasing the number of speakers measured, only |
|
| ||
|
| ||||
| illuminates. | ||||
version Basic
version Advanced
Information
NOTE
• “MultEQ®” and “Manual” cannot be selected when “EQ Customize” is set to “Not Used” (vpage 59).
• When using headphones, “MultEQ®” is automatically set to “OFF”.
“MultEQ®”, “Dynamic EQ®” and “Dynamic Volume®” settings are stored for each input source.
vSee overleaf
BD | 50 |