Symptom | Cause/Solution | Page | |
Audio is not output |
| • Check that the Bluetooth device and Wireless receiver (RX101) | 10, 86 |
when a wireless |
| are correctly paired. |
|
receiver (RX101 is |
|
|
|
connected). |
|
|
|
GRemote Control UnitH |
|
| |
Symptom | Cause/Solution | Page | |
The set cannot be |
| • Batteries are worn out. Replace with new batteries. | 78 |
operated with the |
| • Operate the remote control unit within a distance of about | 78 |
remote control unit. |
| 7 m from this unit and at an angle of within 30°. |
|
|
| • Remove any obstacle between this unit and the remote control | 78 |
|
| unit. |
|
|
| • Insert the batteries in the proper direction, checking the q and | 78 |
|
| w marks. |
|
|
| • The set’s remote control sensor is exposed to strong light (direct | 78 |
|
| sunlight, inverter type fluorescent bulb light, etc.). Move the set |
|
|
| to a place in which the remote control sensor will not be exposed |
|
|
| to strong light. |
|
|
| • The operation mode does not match the settings of the device to | 68 |
|
| operate. Check the operation mode. |
|
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values.
ON/STANDBY ENTER
RETURN
1 Turn off the power using ON/STANDBY.
2 Press ON/STANDBY while simultaneously pressing ENTER and RETURN.
3 Once the display starts flashing at intervals of about 1 second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
version Basic
version Advanced
Information
89