Registering preset codes
When preset codes are registered in the included remote control unit, it can then be used to operate any devices you have, such as DVD players or TVs made by different manufacturers.
NOTE
•No preset codes other than BD, DVD, SAT, TV and CD can be registered.
•In the factory settings, remote control codes for all marantz products are registered.
nnButtons used for operating the devices
q SOURCE Z / X
For switching power of each device on or off.
wuio p, ENTER
For menu operation of each device.
eMENU, SHIFT/TOP MENU
For displaying the menu of each device.
r3, 1, 2, 8, 9, 6, 7 t Number button (0 – 9, +10)
y PRESET +, PRESET – u TV Z / X, TV INPUT
For operating a TV
This button is enabled in any mode.
For details on operation with the remote control unit, see pages 23, 71, 72.
Registering preset codes
The following two methods can be used for registering the reset code.
qEntering a
qEntering a
See the preset code list table for the code to be input.
1 Press and hold down the input source select buttons for the appliance to control, and press SET until the SET indicator blinks.
2 Press the
When the procedure is successful, the
SEND indicator blinks twice.
NOTE
If the SEND indicator did not blink twice, then repeat steps 1 and 2 and try entering the same code again.
69
wScanning the code table
1 Switch the power of the appliance to which you want to register the preset code to ON.
2 Press and hold down the input source select buttons for the appliance to control, and press SET until the SET indicator blinks.
3 Aim the remote control at the appliance and slowly alternate between pressing SOURCE d and SOURCE Z /X for the appliance.
4 When the power of the appliance that you want to register has turned off, release the button.
5 Press ENTER.
When the procedure is successful, the
SEND indicator blinks twice.
vSee overleaf
version Basic
version Advanced
Information