Set up speakers (Audyssey® Setup)

Error messages

NOTE

An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the necessary measures. Then perform Audyssey® Setup again.

If the result still differs from the actual connection status after re-measurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning.

Be sure to turn off the power before checking speaker connections.

 

Examples

 

Error details

Measures

Audyssey Setup

 

• The connected Setup and measurement microphone is broken, or a device

• Connect the included Setup and measurement microphone to the SETUP

Caution!

 

 

other than the supplied Setup and measurement microphone is connected.

MIC jack of this unit.

 

 

• Not all speakers could be detected.

• Check the speaker connections.

Microphone or Speaker is none

 

 

 

 

Please check the cable connection

 

 

 

and retry.

 

 

 

 

Retry

 

 

 

 

Audyssey Setup

 

• There is too much noise in the room for accurate measurements to be

• Either turn off any device generating noise or move it away.

Caution!

 

 

made.

• Perform again when the surroundings are quieter.

 

 

• Speaker or subwoofer sound is too low for accurate measurements to be

• Check the speaker installation and the direction in which the speakers are

Ambient noise is too high or level is

 

 

made.

facing.

too low

 

 

 

 

 

 

• Adjust the subwoofer’s volume.

Retry

 

 

 

 

Audyssey Setup

 

• The displayed speaker could not be detected.

• Check the connections of the displayed speaker.

Caution!:Please check the cable connection

(The screen on the left indicates that the front right speaker cannot be

 

detected.)

 

and retry.

 

 

Front R

None

 

 

 

Retry

 

 

 

 

Audyssey Setup

 

• The displayed speaker is connected with the polarity reversed.

• Check the polarity of the displayed speaker.

Caution!:Please check the cable connection

(The screen on the left indicates that the polarity phases of the front right

• For some speakers, this error message may be

speakers are reversed.)

displayed even if the speaker is properly connected.

and retry.

 

 

 

 

 

If you are sure the connection is correct, use p to

Front R

Phase

 

 

select “Skip”, then press ENTER.

Retry

Phase Info.

Skip

 

 

28

DVD

instructions Advanced instructions Basic

Information