Setting items

Setting details

 

 

Distances

Unit : Set the unit of distance.

Set distance from listening

• Feet / Meters

position to speakers.

Step : Set the minimum variable width of the distance.

Measure beforehand the

• 1ft / 0.1ft

distance from the listening

• 0.1m / 0.01m

position to each speaker.

 

Set Defaults : The “Distances” settings are returned to the default

 

 

settings.

 

• Reset : Reset to the defaults.

 

• Cancel : Do not reset to the defaults.

 

When you select “Set Defaults” and press

 

ENTER, the “Resets all of the distance

 

settings to the factory defaults?” prompt is

 

displayed. Select either “Reset” or “Cancel”,

 

and press ENTER.

Front L / Front R / F. Height L / F. Height R / Center / Subwoofer / Surround L / Surround R / Surr. Back Lz / Surr. Back Rz : Select speaker for distance setting.

zWhen the “Speaker Config.” – “Surr. Back” setting (vpage 124) is set to “1spkr”, “Surr. Back” is displayed.

•0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.

•The speakers that can be selected differ depending on the “Amp Assign” (vpage 124) and “Speaker Config.” (vpage 124) settings.

•Default settings :

Front L / Front R / F. Height L / F. Height R / Center / Subwoofer : 12.0 ft (3.60 m)

Surround L / Surround R / Surr. Back L / Surr. Back R : 10.0 ft (3.00 m)

•Set the difference in the distance between the speakers to less than 20.0 ft (6.00 m).

NOTE

“Distances” cannot be set for speakers with “Speaker Config.” (vpage 124) set to “None”.

 

Speakers

 

 

Setting items

Setting details

 

 

Levels

Test Tone Start : Output test tone.

Set the volume of the test

• Front L / F. Height L / Center / F. Height R / Front R / Surround R /

tone to be the same when it

Surr. Back Rz / Surr. Back Lz / Surround L / Subwoofer : A test tone

is output from each speaker.

is output from the selected speaker. While listening to the test tone,

 

adjust the volume output from the selected speaker.

 

zWhen the “Speaker Config.” – “Surr. Back” setting (vpage 124) is

 

set to “1spkr”, “Surr. Back” is displayed.

 

• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.

 

When “Levels” is adjusted, the adjusted values are set for all the

 

sound modes.

NOTE

•“Levels” cannot be set for speakers with “Speaker Config.” (vpage 124) set to “None”.

•When headphones are connected to the PHONES connector on this unit, you cannot set “Levels”.

Set Defaults : The “Levels” settings are returned to the default settings.

•Reset : Reset to the defaults.

•Cancel : Do not reset to the defaults.

When you select “Set Defaults” and press ENTER, the “Reset all of the channel level settings to the factory defaults?” prompt is displayed. Select either “Reset” or “Cancel”, and press ENTER.

v See overleaf

instructions Advanced instructions Basic

Information

DVD

125