Set up speakers

around items indicate the settings.

This section describes detailed settings for Audyssey® Setup.

First install and connect the speakers to this unit.

Before Audyssey® Setup measurement, the settings shown below can be made.

•Changing the amplifier assignment (Amp Assign)

The signal output from the SURROUND BACK speaker terminals of this unit can be switched to match your speaker environment (vpage 91 “Set up “Amp Assign””).

•Setting the channels to be used (Channel Select)

If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 92 “Set up “Channel Select””).

instructions Basic

1

Set up the zone mode

Press MAIN to switch the zone mode.

MAIN lights.

Press MAIN

2 Connect the Setup and measurement microphone.

When the Setup and measurement microphone is connected, the following screen is displayed.

Audyssey Setup

Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.

Set the following items if necessary.

Amp Assign

Channel Select

Check Results

Restore...

Start

3

Set up “Amp Assign”

Use ui to select “Amp Assign”, and then press

ENTER.

Audyssey Setup

Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.

Set the following items if necessary.

Amp Assign

Channel Select

Check Results

Restore...

Start

Amp Assign

[1/2]

Assign Mode

 

Surround Back

Front

Speaker

 

Center

Speaker

 

Surround

Speaker

 

Surr. Back

Speaker

 

ZONE2

Not Used

 

ZONE2:

Selects how to use the internal amplifiers

4 Select “Assign Mode”, and then press ENTER.

instructions Advanced

Information

v See overleaf

91

DVD