q Remove the rear lid in the | w Load the two batteries properly |
direction of the arrow and | as indicated by the marks in the |
remove it. | battery compartment. |
| R03/AAA |
ePut the rear cover back on.
NOTE
• Insert the specified batteries in the remote control unit. |
• Replace the batteries with new ones if the set does not operate |
even when the remote control unit is operated close to the unit. (The |
supplied batteries are only for verifying operation. Replace them |
with new batteries at an early date.) |
• When inserting the batteries, be sure to do so in the proper direction, |
following the q and w marks in the battery compartment. |
• To prevent damage or leakage of battery fluid: |
• Do not use a new battery together with an old one. |
• Do not use two different types of batteries. |
• Do not attempt to charge dry batteries. |
• Do not |
Point the remote control unit at the remote sensor when operating it.
Approx. 23 ft/7 m
30° 30°
NOTE
•The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.
•When using 3D video devices that transmit infrared communication signals (such as infrared signals etc) between the various units (such as the monitor, 3D glasses, 3D transmitter unit etc), the remote control unit may not operate due to interference from those communication signals. If this occurs, adjust the direction and distance of the 3D communication for each unit, and check that the remote control unit operation is not affected by these signals.
Remote control unit
Specifying the zone used with the remote control unitWhen the ZONE2 button is pressed, only the MAIN ZONE can be operated with the remote control unit.
Press and hold ZONE2 and SETUP.
MAIN and ZONE2 button blink.
instructions Advanced instructions Basic
Information
flames. |
• Do not keep the battery in a place exposed to direct sunlight or in |
places with extremely high temperatures, such as near a heater. |
• If the battery fluid should leak, carefully wipe the fluid off the inside |
of the battery compartment and insert new batteries. |
• Remove the batteries from the remote control unit if it will not be in |
use for long periods. |
• Used batteries should be disposed of in accordance with the local |
regulations regarding battery disposal. |
• The remote control unit may function improperly if rechargeable |
batteries are used. |
DVD
Press and hold ZONE2 and SETUP.
MAIN and ZONE2 button blink.
142