Language

Default settings are underlined.

 

 

Set the language for display on the menu screen.

Setting details

English / Français / Español

“Language” can also be set by the following procedure. However, the menu screen is not displayed. Following the display content to make the setting.

1.Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3 seconds. “V.Format:<NTSC>” appears on the display.

2.Press the main unit’s DISPLAY and set “Lang.:<ENGLISH >”.

3.Use the main unit’s ZONE2 SOURCE or INTERNET RADIO and set the language.

4.Press the main unit’s STATUS to complete the setting.

ZONE2 Setup

Default settings are underlined.

Set the audio to play back with multi-zone (ZONE2).

Setting items

Setting details

 

 

Lch Level

–12dB – +12dB (0dB)

Adjust the left channel

 

output level.

 

Rch Level

–12dB – +12dB (0dB)

Adjust the right channel

 

output level.

 

Volume Level

Variable : Volume adjustment is enabled by main unit and remote control

Set the volume output level. unit.

 

1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.

Volume Limit

60 (–20dB) /70 (–10dB) /80 (0dB)

Make a setting for

Off : Do not set a maximum volume.

maximum volume.

This is displayed from –79 dB to 18 dB when “Scale” (vpage 112)

 

is set to “–79.5dB – 18.0dB”.

General

Setting items

Setting details

Power On Volume

Last : Use the memorized setting from the last session.

Define the volume setting

Mute : Always mute when power is turned on.

that is active when the

1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.

power is turned on.

This is displayed from –79 dB to 18 dB when “Scale” (vpage 112)

 

 

is set to “–79.5dB – 18.0dB”.

Mute Level

Full : The sound is muted entirely.

Set the amount of

–40dB : The sound is attenuated by 40 dB down.

attenuation when muting

–20dB : The sound is attenuated by 20 dB down.

is on.

 

Zone Rename

Change the display title of each zone to one you prefer.

Setting details

MAIN ZONE / ZONE2

•Up to 10 characters can be input.

•For character input, see page 107.

Set Defaults : The input source name is returned to the default setting.

• Reset : Reset to the defaults.

•Cancel : Do not reset to the defaults.

If you select “Set Defaults” and press ENTER, the message “Reset all zone names to the factory defaults?” is displayed. Select “Reset” or “Cancel”, and then press ENTER.

instructions Advanced instructions Basic

Information

DVD

132