1 | Prepare the included Setup and |
| measurement microphone |
Mount the Setup and measurement microphone on a tripod or stand and place it in the main listening position.
When placing the Setup and measurement microphone, adjust the height of the sound receptor to the level of the listener’s ear.
Sound receptor | Setup and |
| measurement |
| microphone |
If you do not have a tripod or stand, set up the microphone on, for example, a seat without a back.
NOTE
•Do not hold the Setup and measurement microphone in your hand during measurements.
•Avoid placing the Setup and measurement microphone close to a seat back or wall as sound reflections may give inaccurate results.
DVD
2 | Set up the subwoofer |
If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below.
For details, see your subwoofer’s manual.
nn When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment and crossover frequency setting.
nn When using a subwoofer without a direct mode
Make the following settings:
•Volume : “12 o’clock position”
•Crossover frequency : “Maximum/Highest Frequency”
•Low pass filter : “Off”
•Standby mode : “Off”
3 | Set up the zone mode |
Press MAIN to switch the zone mode.
MAIN lights.
Press MAIN
23
Set up speakers (Audyssey® Setup)
Preparation4 Connect the Setup and measurement microphone to the SETUP MIC jack of this unit.
When the Setup and measurement microphone is connected, the following screen is displayed.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.
Set the following items if necessary.
Amp Assign
Channel Select
Check Results
Restore...
Start
•Here, we explain setup using the example of
For settings other than
If unused channels are set with “Channel Select”, measuring time can be shortened. For setting, perform steps 7 to 12 of “Set up “Channel Select”” (vpage 92).
vSee overleaf
instructions Advanced instructions Basic
Information