5 Use o p to select the configuration of the connected speakers, and then press

ENTER.

Surround Back Setting for 7.1-channel playback using surround back speakers.

ZONE2 Setting to assign the unit’s built-in power amplifier for ZONE2 and output the audio in stereo.

Bi-AMPSetting to use the front speakers via the bi-amp connection.

Front B Setting to use the second set of front speakers for playback.

Front Height Setting for 7.1-channel playback using front height speakers.

6 Press o or BACK to exit the “Amp Assign” setting.

7

Set up “Channel Select”

Use ui to select “Channel Select”, and then press

ENTER.

Audyssey Setup

Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.

Set the following items if necessary.

Amp Assign

Channel Select

Check Results

Restore...

Start

Channel Select

 

Subwoofer

Measure

Surround Back

Measure(2spkrs)

 

 

8 Use ui to select a channel, and then press ENTER.

Front Select for setting the front speakers to be used. In this case, go to step 9.

•“Front” can be set when “Assign Mode” is set to “Front B”.

Subwoofer Select for no subwoofers to be used. In this case, go to step 10.

Surround Select the number of surround back speakers to be

Back used. In this case, go to step 11.

•“Surround Back” can be set when “Assign Mode” is set to “Surround Back”.

Set up speakers

9 Use o p to select a front speaker, and then press

ENTER.

ASelect this to use front speaker A.

BSelect this to use front speaker B.

A+B Select this to use front speakers A and B simultaneously.

10Use opto set whether or not a subwoofer channel is measured, and then press ENTER.

Measure Set for measuring a subwoofer.

Skip Set for no measuring of a subwoofer.

11Use o p to set whether or not a surround back channel is measured, and then press ENTER.

Measure

Set for measuring two surround back speakers.

(2spkrs)

 

 

Measure

Set for measuring a surround back speaker.

(1spkr)

 

 

Set for no measuring of a surround back speaker.

Skip

12Press o or BACK.

Proceed to page 24 Preparation step 5.

NOTE

After performing Audyssey® Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey® Setup again.

instructions Advanced instructions Basic

Information

92

DVD