Here we connect the speakers in the room to this unit.
This section explains how to connect them using typical examples.
nn Connecting
nn Connecting
nn Connecting front A/B speakers (vpage 87) nn Connecting
nn Connecting front speakers with a
NOTE
•Disconnect this unit’s power plug from the power outlet before connecting the speakers. Also, turn off the subwoofer.
•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sides touch each other (vpage 151 “Protection Circuit”).
•Never touch the speaker terminals while the power cord is connected. Doing so could result in electric shock. When the “Setup Assistant” is running, follow the instructions in the “Setup Assistant” screen for making connections. (Power is not supplied to the speaker terminals while the “Setup Assistant” is running.)
•Use speakers with the speaker impedances shown below.
Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to this unit, and be sure to connect the channels and polarities correctly.
1 Peel off about 3/8 inch (10 mm) of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.
2 Turn the speaker terminal counterclockwise to loosen it.
3 Insert the speaker cable’s core wire to the hilt into the speaker terminal.
4 Turn the speaker terminal clockwise to tighten it.
instructions Advanced instructions Basic
Information
Speaker terminals | Speaker impedance |
FRONT
CENTER6 – 16 Ω/ohms
SURROUND
SURROUND BACK
81
DVD