Measurement (2nd – 6th)

•In this step, you will perform measurements at multiple positions (one to five additional positions) other than the main listening position.

•Just one listening position can be measured if you so choose, but measuring multiple positions increases the accuracy of the correction of acoustic distortion within the listening area.

10Move the Setup and measurement microphone to

position 2, select “Continue”, and then press ENTER.

The measurement of the second position starts. Measurements can be made in up to six positions.

Audyssey Setup

Place the microphone at ear level at the 2nd listening position,

then select “Continue”...

Continue

Calculation

Back

Audyssey Setup

Measuring the LEFT FRONT SPEAKER...

Cancel

•To skip measuring the second and subsequent listening position, use i to select “Calculation” and press ENTER to proceed to step 13.

•To measure the second position again, use i to select “Repeat Last Test” and press ENTER.

11Repeat step 10, measuring positions 3 to 6.

When measurement of position 6 is completed, a “Measurements finished.” message is displayed.

Audyssey Setup

Measurements finished.

Calculation

Repeat Last Test

Set up speakers (Audyssey® Setup)

Calculation

12Select “Calculation” and then press ENTER. Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined.

Audyssey Setup

Calibration completed! Now calculating...Please wait.

50%

•Analysis takes several minutes to complete. The more speakers and measurement positions that there are, the more time it takes to perform the analysis.

vSee overleaf

instructions Advanced instructions Basic

Information

DVD

25