Set up speakers (Audyssey® Setup)
| Check | Store | Finish |
instructions Basic
13Use ui to select the item you want to check, and then press
ENTER.
Audyssey Setup
Check processing results. To proceed, press “Store”.
Speaker Config.
Distances
Levels
Crossovers
Store
•Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers.
•If you want to check another item, press BACK.
NOTE
•If the result differs from the actual connection status, or if “Caution!”
is displayed, see “Error messages” (vpage 27). Then carry out Audyssey® Setup again.
•If you change speaker positions or orientation, perform Audyssey® Setup again to find the optimal equalizer settings.
DVD
14Select “Store” and then press ENTER. Save the measurement results.
Audyssey Setup
Check processing results. To proceed, press “Store”.
Speaker Config.
Distances
Levels
Crossovers
Store
Audyssey Setup
Now storing...Please wait.
50%
•Saving the results requires about 20 seconds.
•During saving of measurements results, “Now storing...Please
wait.” is displayed. When saving is completed, “Storing complete. Audyssey® Setup is now finished. Please unplug microphone.” is displayed.
NOTE
During saving of measurement results, be sure not to turn off the power.
26
15Unplug the Setup and measurement microphone from the unit’s SETUP MIC jack.
16Set Audyssey Dynamic Volume®.
Audyssey Setup
You can set Dynamic Volume function, which automatically adjust volume level for all content.
Do you want to enable?
Yes
No
•This feature adjusts the output volume to the optimal level while constantly monitoring the level of the audio input to the unit. Optimal volume control is performed automatically without any loss in the dynamism and clarity of the sound when, for example, the volume suddenly increases for commercials shown during television programs.
nn When turning Dynamic Volume on
•Press u to select “Yes”, and then press ENTER.
The unit automatically enters “Medium” (vpage 113) mode.
nn When turning Dynamic Volume off
•Press i to select “No”, and then press ENTER.
NOTE
After performing Audyssey® Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey® Setup again.
instructions Advanced
Information