GRemote control unitH

Symptom

Cause/Solution

Page

The set cannot be

• Batteries are worn out. Replace with new batteries.

142

operated with the

• Operate the remote control unit within a distance of about

142

remote control unit.

23 ft/7 m from this unit and at an angle of within 30°.

142

 

• Remove any obstacle between this unit and the remote control

 

unit.

142

 

• Insert the batteries in the proper direction, checking the q and

 

w marks.

142

 

• The set’s remote control sensor is exposed to strong light (direct

 

sunlight, inverter type fluorescent bulb light, etc.). Move the set

 

 

to a place in which the remote control sensor will not be exposed

 

 

to strong light.

 

 

• The setting of the zone to operate does not match. Press MAIN or

23, 91, 101

 

ZONE2 to select the zone to operate.

 

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed. Note that when the microprocessor is reset, all the settings are reset to their default values.

XM-DAX

ZONE2 SOURCE

1 Turn off the power using X.

2 Press X while simultaneously pressing M-DAXand ZONE2 SOURCE.

3 Once the display starts flashing at intervals of about 1 second, release the two buttons.

instructions Advanced instructions Basic

If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.

Information

DVD

157