Preparation (Continued)

Set up speakers (Audyssey® Setup)

Detection & Measurement (Main)

instructions Basic

5 Select “Start” and then press

ENTER.

Audyssey Setup

Connect the calibration microphone to the SETUP MIC input on the front the AV receiver.

BackNext

6 Select “Next” and then press ENTER.

The subwoofer volume setting screen is displayed.

Audyssey Setup

Make sure your subwoofer is plugged in and turned on. If your

subwoofer has a volume control on it, please set it at 50%...

POWER

VOLUME

ON

 

 

OFF

MIN

MAX

Back

Next

 

 

DVD

This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency.

It also corrects distortion in the listening area.

7 Select “Begin Test” and then press ENTER.

When measuring begins, a test tone is output from each speaker.

•Measurement requires several minutes.

8 The detected speakers are displayed.

•The illustration below shows an example of when the front speakers, center speaker, subwoofer, surround and surround back speakers have been detected.

Audyssey Setup

Speaker Detection

 

Front

:Yes

 

Center

:Yes

 

Subwoofer

:Yes

 

Surround

:Yes

 

Surr. Back

:2spkrs

 

Repeat Last Test

Next

NOTE

If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection.

9 Select “Next” and then press ENTER.

24

NOTE

If “Caution!” is displayed on TV screen:

Go to “Error messages” (vpage 27). Check any related items, and perform the necessary procedures.

If the problem is resolved, return and restart “Audyssey® Setup”.

Going back to the previous screen

Select “Back” and then press ENTER.

When measuring has stopped

qPress BACK to display the popup screen.

wPress o to select “Yes”, and then press ENTER.

Setting up the speakers again

Repeat the operation from step 4.

v See overleaf

instructions Advanced

Information