Customizing your RC5400

7Switch back to DELETE mode and delete the device if it is not a good match to your component. Repeat steps 4 through 7 until all of your remote controls have matching devices.

8Switch to LABEL mode to relabel each device (see page 30-32).

9Switch to MOVE mode to re-order your devices, so that your Device Overview page is arranged the way you want (see page 39).

10 Switch to LABEL mode to relabel any buttons as needed to match your existing remote controls. Check all of your devices.

12 Switch to LEARN mode and teach the RC5400 all of your non- Marantz components’ RC Codes (see page 26-30).

13Switching back and forth between USE and LEARN modes, test all codes and reteach as necessary.

Note

Be very careful to NEVER delete the jump tabs; they can only

 

be restored with a Editor software using PC. (see page 46-47).

14Switch back to LEARN mode. Teach each Device the appropriate Preamp/Receiver Input (source switching) IR command (see page 28) as the Device Action.

Congratulations!

You have completed the first stage of customization. Take a well deserved break.

UserGuide

17