Marantz RC5400 5.Moving Devices

Reference

5.Moving Devices

You can change the order of device buttons in the Device Overview pages.

1Tap and hold the MODEicon in the LOWER TOOL BAR more than 3 seconds. Mode Menu page will appear.

2Tap the MOVE button to switch to the MOVE mode.

The RC5400 displays the Device list box.

3Tap the device name of your choice. The point next to the selected device name is highlighted.

4Tap the Move and buttons below the Device list box to move

the device up or down.

5Tap the Done button to save the changes. You return to Mode Menu page.

UserGuide

39

Contents

Page FCC Compliancy: Declaration of Conformity N¡ V03ECRC5400: Page Automating Your Home Theater With The Marantz RC5400 Introduction Getting Started Customizing Your RC5400 Reference Maintaining the RC5400 1.The Marantz RC5400 The Touch Screen 2.The Battery Installing the Battery Pack Charging the RC5400 1.Activating the RC5400 Turning on the Touch Screen Using the Backlight Modes Navigating the RC5400 Navigating the Devices The commands assigned to the device button called the Device Action Device Overview Using Device Overview 1.Display the Device Overview page, by tapping the DEVICE OVERVIEW button Navigating the Pages Other Navigation 3.Operating a Device Using the Soft Buttons Using the Hard Buttons Check Battery Life 5.The Setup Pages First Setup page Second Setup page Third Setup page 6.The Mode Menu 7.Adjusting the Touch Screen Contrast Introduction Cloning All Your Existing Remotes Switch back to 8Switch to LABEL mode to relabel each device (see page 30-32) MOVE Switching back and forth between Complex Operation? Macro or Help Page 4.Programming Help List 5.Macro/Page Jump Capability Any Button Perform Macros/Jumps Macros Perform Jumps to Any Device Macros Send Commands To Your System Macros Can Contain Delay and Beep Between Steps 6.Programming Macros & Page Jumps Commands button Jumps Action Delays and buttons to reposition it within the Macro page Done 14 Continue to program macros until you have recorded all that you plan Learning IR command Programming Touch Screen Buttons Programming The Device Buttons to Switch Sources Programming Hard Buttons Globally And/Or Locally Per Device Programming a Hard Button Locally 2.Labeling Buttons, Pages and Devices Labeling a Button Delete Font Shift Enter Cancel Labeling a Device Labeling a Page 3.Adding Devices Description for the Template Device and the Tuner section in Creating a New Device Step by Step Copy Existing Device Deleting Buttons and Devices Deleting a Button Deleting a Device 5.Moving Devices Programming Macros Macro Page Notation Recording a Macro to a Operation Button Step By Step Recording a Macro to a Device Button Step By Step Editing Macros 7.Using the RC5400 with Radio Frequency Changing the IR / RF Settings 3Select the device for which you want to change the IR / RF settings 4Tap RF button. The IR/RF settings for the selected device are changed from IR to RF When you have several RX-77s to operate Extender ID 8.Software Internet Fun System requirements Important notice Cleaning the RC5400 General Problems Programming Problems Recharging Problems Can I program a device button to execute more than one command How do I program source switching How can I edit buttons which are programmed macro on Device overview pages How can I label buttons on Device overview pages How can I delete buttons on Device overview pages How do I calibrate the Touch Screen Calibration Touch TOP LEFT corner Touch BOTTOM RIGHT corner Calibration succeeded Page Page Page Page Page Page Page Other Service and Support Updates and New Products Page www.marantz.com