Frequently Asked Questions

User Guide

Can I program a device button to execute more than one command?

Yes, you can. You can program a macro to the device button in the MACRO mode. (see page 42).

How do I program source switching?

See “Programming The Device Buttons ...” on page 28.

How can I edit buttons which are programmed macro on Device overview pages?

You can do this using Macro to device function via the MACRO mode. (page 43).

How can I label buttons on Device overview pages?

You can do this using Label device function via the LABEL mode. All changes you make to these items are automatically updated in the Home page (page 32).

How can I delete buttons on Device overview pages?

You can do this using Delete device function via the DELETE mode. All changes you make to these items are automatically updated in the Home page (page 38).

How do I reset the RC5400?

Normally, you never have to reset the RC5400. However, if the RC5400’s display freezes or if you notice unusual behavior, you might need to reset the RC5400. You will not lose any saved programmed commands or macros.

Carefully press the reset button near the battery connector inside the battery compartment of the RC5400 with a paperclip or sharp pencil. The RC5400 restarts and beeps to indicate it is ready for use.

Can I revert to the original configuration?

Yes, by using the Revert function on the third Setup page or Wizz.it with Windows PC. By using Wizz.it, once the program is installed, open a configuration file named RC5400_default in C/:Program Files/Wizzit/Samples. Downloading this configuration to your RC5400 will restore your RC5400 to its factory state except the setup items.

52