Troubleshooting

General Problems

The display is blank

■Tap the screen to make sure the RC5400 is turned on.

■Adjust the screen contrast using the buttons on the left side (page 15).

■Make sure the batteries are properly installed (page 4).

■Recharge the battery pack using the docking station (page 5).

The display is too light or too dark

■Adjust the screen contrast using the buttons on the left side (page 15).

The RC5400 shuts itself off

■This is a feature of the RC5400 to save power. You can change the length the RC5400 stays on in the Setup (page 13).

Devices do not respond to commands from the RC5400

■Make sure the RC5400 is in USE mode (page 7).

■Make sure the RC5400’s IR sending eye is pointed towards the device you’re operating.

■Check if the Low Battery icon appears. If so, recharge the battery pack using the docking station.

■Check if the button you are trying to use is programmed properly (page 18).

■Check if your device understands these particular Marantz infrared codes. Re-add the device with the correct model number (page 33).

The RC5400 beeps 4 times after inserting the batteries

■Use the Firmware Updater to update the RC5400’s software. The Firmware Updater file will be provided from our website.

User Guide

49