Marantz SR4003 English, Connecting Digital Audio Components, Connecting Audio Components, Basic

CONNECTING AUDIO COMPONENTS

CD recorder

CD player

Tape Deck

DIGITAL

OUT IN

OUTPUT

L

L

R

R

DIGITAL

DIGITAL

OUT IN

L

R

L

R

INPUT

OUTPUT

L

L

R

R

L

R

R L

R L

L

R

INPUT

VIDEO

1

INPUT

3

COMPONENT

VIDEO

FM (75Ω)

S-VIDEO

MONITOR

GND

AM

OUT

INPUT 1

INPUT 2

INPUT 3

OUTPUT

ANTENNA

INPUT

TV

DVD

VCR IN VCR OUT

DSS

MONITOR OUT

2

Y

CB/PB

CR/PR

Y

CB/PB

CR/PR

L

SL

C

SBL

IN

L

3

4

R

R

SR

SW

SBR

IN

OUT

IN

OUT

IN

OUT

1

2

OPT

OUT

FLASHER

(AUX 2)

7.1CH INPUT

TV

DVD

VCR

DSS

TAPE

CD/CDR

DIGITAL IN

DIGITAL OUT REMOTE CONT.

IN

AUDIO

			AC IN
L	SL	C	SBL

		R	L	R	L	R	L		AC OUTLETS
									120V 60Hz
			FRONT	SURROUND BACK		SURROUND		CENTER	SWITCHED
R	SR	SW SBR		S. SPEAKER B					1.25A 150W
				SPEAKER SYSTEMS : 6-8 OHMS						MODEL NO. SR4003

PRE OUT

R L R L

The output audio signal from the TAPE OUT jack and the CD/CD-R OUT jack is the same signal which is currently selected.

Caution:

Do not connect this unit and other components to mains power until all connections between components have been completed.

Notes:

•Insert all plugs and connectors securely. Incomplete connections may make noise.

•Be sure to connect the left and right channels properly.

Red connectors are for the R (right) channel, and white connectors are for the L (left) channel.

•Be sure to connect input and output properly.

•Refer to the instructions for each component that is connected to this unit.

•Do not bind audio/video connection cables with power cords and speaker cables this will result in generating a hum or other noise.

ENGLISH

CONNECTING DIGITAL AUDIO COMPONENTS

•There are 4 digital inputs, 2 coaxial jacks and 2 optical jacks, on the rear panel. You can use these jacks to input PCM, Dolby Digital and DTS bitstream signals from a CD, DVD, or other digital source components.

•There is one optical output jack on the rear panel. These jacks can be connected to a CD recorder, or a MD deck inputs, respectively.

•Refer to the instructions for each component. To setup the digital audio format of DVD player, or other digital source’s connected to digital input jacks.

•Use fiber optical cables (optical) for DIG-1,2, input jacks. Use 75 ohms coaxial cables (for digital audio or video) for DIG-3,4, input jacks.

•You can designate the input for each digital input/ output jacks according to your component. See page 21.

Notes:

•There is no Dolby Digital RF input jack. Please use an external RF demodulator Dolby Digital decoder when connecting the Dolby Digital RF output jack of the video disc player to the digital input jack.

•The digital signal jacks on this unit conform to the EIA standard. If you use a cable that does not conform to this standard, this unit may not function properly.

•Each type of audio jack works independently. Signals input through the digital and analog jacks are output through the corresponding digital and analog jacks, respectively.

NAMES AND	FUNCTIONS
BASIC	CONNECTIONS
BASIC OPERATION
ADVANCED	CONNECTIONS
SETUP

Digital AudioLR	(coaxial)	ADVANCED OPERATION
Analog Audio
Digital Audio (optical)		TROUBLESHOOTING

OTHERS

11