Troubleshooting
This section describes problems you may encounter when using the DVD player, and includes suggested solutions.
If these suggestions fail to cure the problem, please contact your Meridian dealer for further assistance.
❍Try playing another disc. If this disc works, check the problem disc for signs of dirt or damage.
❍If you are using the DVD player with a preamplifier or active loudspeakers check that the AUDIO OUT SEL. menu option is set to PCM; see To select the audio output format, page 37.
No lights are displayed when switching on
❍Check that your AC power supply is connected correctly.
❍Check that the ON/OFF switch on the back panel is in the ON position.
There is no sound when playing a disc
❍Check that your preamplifier is switched on, and the volume is at an appropriate level.
❍Check that the DVD player is connected correctly to the other components of your system; see Setting up the DVD player, page 53.
❍Check that the correct source has been selected on your preamplifier.
❍Check that the display does not show Pause.
There is interference on the radio and/ or television when the DVD player is switched on
Before following the steps below, ensure all units are switched off first.
If this equipment does cause or suffer from interference to/from radio or television reception then the following measures should be tried:
❍Reorient the receiving aerial (or antenna) or route the antenna cable of the receiver as far as possible from the 586 DVD Player and its cabling.
❍Ensure that the receiver uses
❍Relocate the receiver with respect to the DVD player.
❍Connect the receiver and this product to different AC outlets.
Setting up the DVD player
61
