Milan Technology MIL-SM8002TG manual Mac / Filter Table Commands Set

Mac / Filter Table Commands Set

Commands	Command Level	Description	Defaults	Example
				(Enable)
				Switch (config)#
		Use the mac-address-table		mac-address-table aging-time
				on
		aging-time global
mac-address-table		configuration command to set		Switch (config)#
aging-time [on off]		the length of time that a
				mac-address-table aging-time
		dynamic entry remains in the
	Global			333
mac-address-table		MAC address table after the	300 secs
	configuration mode
aging-time [sec.]		entry is used or updated.
				(Disable)
or no mac-address-table		Use the no form of this
				Switch (config)#
aging-time		command to use the default
				mac-address-table aging-time
		aging-time interval. The aging
				off
		time applies to all VLANs.
				Or
				Switch(config)# no
				mac-address-table aging-time
		Use the mac-address-table		Switch (config)# interface
		static to add static filter
mac-address-table table				fastEthernet 0/2
		addresses to the MAC
[static filter] hwaddr	Interface			Switch (config-if)#
		address table. Use the no	N/A
[MAC address] vlanid	configuration mode			mac-address-table static
		form of this command to
[VLAN-ID]				hwaddr 004063112233 vlanid
		remove static entries from the
				10
		MAC address table.
		Use the no		Switch (config)# interface
no mac-address-table				fastEthernet 0/2
		mac-address-table privileged
[static filter] hwaddr	Interface			Switch (config-if)# no
		EXEC command to delete
[MAC address] vlanid	configuration mode			mac-address-table static
		entries from the MAC
[VLAN-ID]				hwaddr 004063112233 vlanid
		address table.
				10

29