Milan Technology MIL-SM8002TG manual QOS Commands Set

		learning states last before
		the port begins forwarding.
		Use the no form of this
		command to return to the
		default value.
		Use the spanning-tree
		port-priority interface
		configuration command to		Switch (config)# interface
		configure a port priority that
stp-path-priority [Port	Interface			fastEthernet 0/2
		is used when two switches	128
Priority]	configuration mode			Switch (config-if)#
		tie for position as the root
				stp-path-priority 127
		switch. Use the no form of
		this command to return to the
		default value.
QOS Commands Set
Commands	Command Level	Description	Defaults	Example
qos storm-control		Enable/Disable broadcast
	Global	storm control. Use the no form		Switch (config)# qos
[510152025 off (%)]			OFF
	configuration mode	of this command to restore to		storm-control 5
or no storm-control
		default.
qos		Enable/Disable low priority		Switch (config)# qos
low-priority-delay-bound	Global	delay board.
			OFF	low-priority-delay-bound on
[onoff] [sec.] or no qos	configuration mode	Use the no form of this
				1
low-priority-delay-bound		command to restore to default.
qos level [priority]	Global	[Priority] 0~7	0~3 LOW	Switch (config)# qos level
enable	configuration mode		4~7 HI	2,3 enable

26