Millennium Enterprises Integrated Modeling Amplifier Noise Gate Editing, S1Pre Gate, User Guide

Section - 3 Editing Presets

Johnson Millennium

3.The <2> button (pedal parameter) can be assigned to a footswitch to bypass or turn the module On. This parameter can be selected by turning the <2> knob and a Changed icon will appear directly beneath the parameter. At this point press the <Assign> button and the display will appear as follows:

Avail Link for: Pedal 1 OFF

		LINK CHANGED	LINK CHANGED		LINK CHANGED	LINK CHANGED
	2￿ WAH TUBE			EQ	GATE	L/R OUTS
	USER	￿			#DIGITAL
BANK
PAGE	1 OF 19 b

4.Now press the footswitch to be assigned. You can use either a standard volume or voltage controlled Expression pedal connected to the Expression pedal I and 2 pedal inserts on the rear panel of the Millennium or you can use either one of the Expression pedals on the optional J-12 Foot Controller to act as the Wah pedal. If the selected footswitch is already assigned to control another parameter, the display of the Millennium will ask you if you want to re-assign. If you wish to re-assign, turn the <1> knob for yes or the <2> knob to abort the assign function.

Note: Any time an assignment to turn a parameter On/Off is made you must decide if you want the parameter On when you enter the selected preset. If you want it on, make the assignment to the parameter when the parameter is set to On. Otherwise, have the parameter set to Off or Bypass and the parameter will not be active within the Preset until the footswitch is used to activate the parameter

5. To Exit the Analog Wah edit mode, simply press the <Preset> button.

Noise Gate Editing

The procedure for editing the Noise Gate module within the Integrated amplifier section is as follows:

1. From Preset mode, press the <Edit> button and turn the <Preset/Effect> wheel until the display appears something like this:

			Noise Gate				S1Pre Gate
				On		2			F 1
			1					4
			LINK CHANGED			LINK CHANGED	LINK CHANGED	LINK CHANGED
	2￿				WAH TUBE EQ		GATE
										L/R OUTS
BANK	USER	￿					#DIGITAL
PAGE	1 OF 3 b

2.At this point, you can use the <1> knob to turn the Noise gate On or Off and the <4> knob is used to select the Noise gate default.

3.Now use the <Page> knob and turn to page 2 of the Noise Reduction module. Turning the <1> knob lets you select the Noise gate type and its position in the signal flow.

26

User Guide