Millennium Enterprises Integrated Modeling Amplifier The Rear Panel, Introduction, User Guide

Johnson Millennium Section -1 Introduction

The Rear Panel

1 2 3 4 5 6 7 8 9 10

Expression Pedal		MIDI	J3
1	2	In Out/Thru Footswitch		Right Speaker	Left Speaker		FX Return	FX Send
				Speaker Output (4 Ohms Minimium)		Right	Left
						Direct/Record
				J12			Output

1)Fuse- 100, 120 VAC 6 Amp fuse is inserted here.

2)Expression Pedal 1 and 2 Jacks - This is the insert point for an external expression pedal. Standard volume or Voltage controller pedals can be used in these inserts. Once inserted, this expression pedal can be linked to control any parameter of the Millennium. For more about assigning expression pedals, see pg. 57.

Notice: When using the Millennium with the Johnson Amplification J-12 foot controller, the 1/4” Expression pedal inputs on the rear of the unit are referred to as EXP 3 and EXP4. When the Millennium is used alone, the expression pedal inputs are referred to as EXP 1 and EXP 2.

3)MIDI In - The MIDI IN port allows the Millennium to respond to incoming MIDI information.

4)MIDI Out/Thru - This port allows the Millennium to send out or pass MIDI data to other devices.

5)J-3 Footswitch Jack - This is the insert point for the J-3 multi-function footswitch.

6)Johnson Amplification J-12 Foot Controller Input - This is a 5-pin DIN plug for connecting the optional Johnson Amplification J-12 foot controller. Connection of the J-12 should be made before the Millennium is turned on.

IMPORTANT: CONNECTING A DEVICE OTHER THAN THE J-12 OR CONTROL ONE CAN DAMAGE THE UNIT.

7)Left and Right Extension Speaker Outputs - These 4 outputs are used to connect speaker cabinets. Up to 4 extension speaker cabinets can be connected to the Millennium. Make sure that the extension cabinet being connected has at least a 4 ohm load resistance per channel. The ohm load resistance effects how much power the extension cabinet receives from the Millennium.

8)Direct XLR Outputs - These XLR outputs are used for recording direct or for sending the output signal to a live mixing console.

9)Loop Return Jack - This is the effects loop mono return jack. Connect the output of an external effect device here.

10)Loop Send Jack - This is the effects loop send jack.

User Guide

7