.A complete Parts List is available at www.MillerWelds.com
OM-217 455 Page 32
9-2. Maintenance Label And Engine Maintenance Activities
4
3
3
1
8
2
7
6
5
7
!Stop engine and let cool.
Oil And Fuel
1 Oil Drain Valve
2 Oil Filter
Change engine oil and filter according to en-
gine manual.
NOTICE − Close valve and valve cap before
adding oil and running engine.
Fill crankcase with new oil to full mark on dip-
stick (see Section 5-4).
3 Fuel Lines
Replace fuel lines if cracked or worn.
4 Inline Fuel Strainer
Install new filter as shown.
5 Fuel Filter
Replace filter according to engine manual.
Wipe up any spilled fuel.
Start engine, and check for fuel leaks.
!Stop engine, tighten connections as
necessary, and wipe up fuel.
Coolant
6 Radiator Cap
7 Radiator Drain Cocks (One located on
bottom of radiator)
Drain engine coolant according to proce-
dure in engine manual.
Add engine coolant as follows:
8 Thermostat Housing Plug
Remove thermostat housing plug. Add cool-
ant to radiator until coolant is at bottom of fill-
er neck and coolant trickles out of thermo-
stat housing plug hole. This ensures all air is
purged from the system.
Reinstall plug and radiator cap. Check cool-
ant level in overflow bottle.
Engine coolant is a mixture of water and
ethylene glycol base antifreeze. A solution
of 50% antifreeze and 50% water must be
used in this engine. Do not use 100% anti-
freeze or severe damage will occur.