FALLING UNIT can cause injury.
DUse lifting eye to lift unit only, NOT running gear, gas cylinders, or any other accessories.
DUse equipment of adequate capacity to lift and support unit.
DIf using lift forks to move unit, be sure forks are long enough to extend beyond opposite side of unit.
MOVING PARTS can cause injury.
DKeep away from moving parts such as fans.
DKeep away from pinch points such as drive rolls.
DHave only qualified persons remove doors, panels, covers, or guards for maintenance as necessary.
DKeep hands, hair, loose clothing, and tools away from moving parts.
DReinstall doors, panels, covers, or guards when maintenance is finished and before re- connecting input power.
MAGNETIC FIELDS can affect Implanted Medical Devices.
DWearers of Pacemakers and other Implanted Medical Devices should keep away from serv- icing areas until consulting their doctor and the device manufacturer.
OVERUSE can cause OVERHEATING.
DAllow cooling period; follow rated duty cycle.
DReduce current or reduce duty cycle before starting to weld again.
DDo not block or filter airflow to unit.
H.F. RADIATION can cause interference.
D
DHave only qualified persons familiar with electronic equipment install, test, and service H.F. producing units.
DThe user is responsible for having a qualified electrician prompt- ly correct any interference problem resulting from the installa- tion.
DIf notified by the FCC about interference, stop using the equipment at once.
DHave the installation regularly checked and maintained.
DKeep
READ INSTRUCTIONS.
D Use Testing Booklet (Part No. 150 853) when servicing this unit.
DConsult the Owner’s Manual for welding safety
precautions.
DUse only genuine replacement parts from the manufacturer.
6-3. California Proposition 65 Warnings
Welding or cutting equipment produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
For Gasoline Engines:
Engine exhaust contains chemicals known to the State of California to cause cancer, birth defects, or other reproduc- tive harm.
For Diesel Engines:
Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm.
6-4. EMF Information
Considerations About Welding And The Effects Of Low Frequency Electric And Magnetic Fields
Welding current, as it flows through welding cables, will cause electro- magnetic fields. There has been and still is some concern about such fields. However, after examining more than 500 studies spanning 17 years of research, a special blue ribbon committee of the National Research Council concluded that: “The body of evidence, in the committee’s judgment, has not demonstrated that exposure to power- frequency electric and magnetic fields is a
To reduce magnetic fields in the workplace, use the following procedures:
1.Keep cables close together by twisting or taping them, or using a cable cover.
2.Arrange cables to one side and away from the operator.
3.Do not coil or drape cables around your body.
4.Keep welding power source and cables as far away from opera- tor as practical.
5.Connect work clamp to workpiece as close to the weld as possi- ble.
About Implanted Medical Devices:
Implanted Medical Device wearers should consult their doctor and the device manufacturer before performing or going near arc welding, spot welding, gouging, plasma arc cutting, or induction heating operations. If cleared by your doctor, then following the above procedures is recom- mended.
