SECTION 7 − TROUBLESHOOTING
7-1. Set Value Mode
1
Program | Volts | Arc Adjust |
|
Wire Speed | Amps |
Process | Wirefeed |
Wire Type | Gas |
Gas Type | Contactor |
Setup | Adjust | Arc Control |
3
4
2
The Set Value mode is a troubleshooting tool that allows certain robot command values to be manually
1Setup Push Button
2Arc Control Push Button
3Adjust Knob
4Wire Feed Speed/Amps Display Push Button
Enter the Set Value mode by pressing the Setup and Arc Control push buttons at the same time. When in the Set Value mode the display windows briefly shows SET VALU and the blinking LED’s under the display windows indicate whether Volts, Arc Adjust, or Wire Speed can be changed turning the Adjust knob.
Depending on the defined weld process, either volts (MIG) or arc adjust [pulse,
changed in the bottom display. Press the Wire Feed Speed/Amps push button to toggle between selecting information in the top display or bottom display. The LED under the active display will blink to indicate the value that can be changed.
Rotate the Adjust knob to change values.
Exit the Set Value mode by pressing the Setup and Arc Control push buttons at the same time or turning power source off and then back on again.
