Miller Electric TS Operation, Controller Display Definitions, Run List Sub-Menu Definitions, Name

6-3. Operation

1.Energize IH/TS and power source. A coolant flow error should appear on the IH/TS display. Energize the cooler and the error will clear from the display.

2.Set up Temperature Profile − per code requirements (see Section 6-3-2Programming The 2408 Controller).

3.Set up and start Digital Recorder

Digital Recorder (see Section 6-3-3. Batch Recording On The 5100 Digital Recorder)

4.Run the heat process (see Section 6-3-4. Running A Heat Treat and the following tables).

5.Recover from an interruption, if applicable (see Section 6-3-5. Recovering From An Interruption).

6.Retrieve data

Digital Recorder (see Section 6-3-3-4. Batch Recording On The 5100 Digital Recorder) View and print data (see Section 6-3-6Review Software).

Name

Home

OP

Table 6-1. Controller Display Definitions

Description

Home List (extra parameters may be present.)

Measured value and Setpoint

% Output level

Table 6-2. Run List Sub-Menu Definitions

run	program run List
StAt	Program status (OFF, run, hoLd, HbAc, End)
PSP	Programmer setpoint
SEG	Active segment number
StyP	Active segment type
SEG.t	Segment time remaining in the segment units
tGt	Target setpoint
rAtE	Ramp rate (if a rate segment)
PrG.t	Program time remaining in hours
SEG.d	*Flash active segment type in the lower readout of the home display (no/YES)
FASt	Runs through program 10 times faster than normal

*This parameter can only be changed when the program is in reset.

OM-203 185 Page 19