FOR OWNERS OF THE QUARTZ DATE MODEL
The
•In this section, when the ADJUST button is referred to, it is the ADJUST button for the Quartz Data function. It is not the adjust button in the control panel.
| SELECT button |
| |
MODE | ADJUST | ||
indicator | |||
button | button | ||
|
SETTING THE DATE AND TIME
Press the MODE button to choose the data imprinting format.
• M will appear above the month.
• The display will change as follows:
year, month, day | no imprinting | |
day, month, year | month, day, year |
|
Use the SELECT button to move between different parts of the displayed data. The selected part will blink, indicating that it is the data to be changed.
112
Press the ADJUST button to change the data to the correct value. Data continues changing as long as the button is held down.
• In time mode, pressing the ADJUST button while : is blinking resets the second counter to 00.
When all data is correct, press the SELECT button until the data stops blinking.
• The print indicator will flash for 2 seconds after the picture is taken to indicate that the data was imprinted.
•Imprinted data may be difficult to read if the
•Imprinting position and size may differ according to printing conditions.
•Do not use the data back when temperatures exceed the operating range of 0° to 50° C (32° to 122° F).
REPLACING THE QUARTZ DATA BACK BATTERY
The quartz data back uses a CR2025 lithium battery, located on the inside of the back cover. Replace the battery if the display changes or becomes dim while the camera batteries are removed.
Slide the battery cover in the direction indicated.
Remove the old battery and replace it with a new one.
• The + side should face up.
Replace the battery cover, then reset the date and time.
113
