Installation .2

Chapter 2 - Installation

Connecting to the R100 Wireless Gateway

Wired Connection

One RJ-45 cable is supplied with the R100 Wireless Gateway. Auto crossover functionality is built-in to the gateway, so you can use either a straight-through or a crossover ethernet cable. Plug one end of the cable into the WAN port on the rear of the wireless gateway and the other end into the ethernet port of your ADSL or Cable modem.

Wireless-Connection

Refer to your wireless adapter’s user manual on associating with the R100. The default SSID of the gateway is “default” (lower case), encryption is disabled and open system authentication is used.

Printer Connection

A DB-25 parallel cable should be supplied with your printer. Plug the male connector of this cable into the printer port on the rear of the R100 and the centronics end into your printer.

18

R100 Wireless Gateway