Mitsubishi Electronics R100 AP Mode, Channel, Connect to APs in Remote Bridge List (Yes/No), Allow anonymous? (Yes/No), Yes, Yes, Hybrid:, AP Only:, WDS Only:

Utilities .3

Chapter 3 - Software Configuration

AP Mode

AP (Access Point) Mode configures the R100 Wireless Gateway for a specific application. By default, the R100 is configured as an Access Point which enables wireless mobile clients to connect to a wired Ethernet network. The following options are available from the drop- down list:

AP Only: the R100 Wireless Gateway acts only as an Access Point.

WDS Only: the R100 Wireless Gateway can only communicate with other Access Points.

Hybrid: Hybrid allows you to use the R100 Wireless Gateway both as an access point and as a wireless bridge.

Channel

Both Access Points in Wireless Bridge mode must be set to the same channel.

Connect to APs in Remote Bridge List (Yes/No)

Select Yes to connect to access points in the remote bridge list.

Allow anonymous? (Yes/No)

Select Yes to allow users without accounts to connect.

Note: If Connect to APs in Remote Bridge List and Allow Anonymous are both set to No, it means that this AP will not connect with other APs and therefore the AP mode setting will return to AP Only.

34 R100 Wireless Gateway