Mitsubishi Electronics R100 MAC Address, Yes, Yes, AP Only, Allow anonymous, Remote Bridge List, Remote Bridge List, Chapter 3 - Software Configuration

Chapter 3 - Software Configuration

Remote Bridge List

MAC Address

Enter the MAC address of the target R100 Wireless Gateway in order to designate which other gateway will be the partner for this gateway.

You can set up your wireless environment as shown in this figure:

3. Utilities

Note: The content in brackets “( )” is the MAC address in the Remote Bridge List of the AP. For example, WB1 has the MAC address of WB in its Remote Bridge List.

In this case, there are six R100s and they are linked as wireless bridges. Take one of them, named WB, as an example. WB is not in AP Only mode and Connect to APs in Remote Bridge List is set as Yes, so it can connect to WB3. Meanwhile, Allow anonymous is set as Yes or No, but it has the MAC addresses of WB1, WB2, and WB4 in the Remote Bridge List, so it can be connected to by WB1, WB2, and WB4.

R100 Wireless Gateway 35