Monarch 9406 Stop Bits

3. Press or to display the word length you need, then

press . You will see

PORT SETTINGS

< Word Length >

4. Press to exit to the Setup menu.

5. Press to exit to the Main Menu.

NOTE: After changing settings in th e Setup Menu, always

return to the Main Menu b efore turning your

printer off. The printer will not save changes to

these menus if you turn it off be fore returning to

the Main Menu.

Stop Bits

The default setting for Stop Bits is 1. To change the setting,

follow the steps listed under "Finding Communication Value

Options." Then follow the ste ps below.

1. Press until you see

PORT SETTINGS

< Stopbits >

2. Press . You will see the previous setting, for example,

STOPBITS

The options for Stop Bits are

9406 Operator’s Handbook

Contents

Main Page Table of Contents i ii 1. Introduction About This Manual 1-1 Menu Charts Other Documentation Menu Structure 1-2 Page New 9406 Features 1-4 Terms You Should Know 1-5 Page 2. Getting Started Turning the Printer On Equipment Manual 2-2 Using the Keypad Control Keys Start Up Selecting a Function 2-3 2-4 Exiting an Option 3. Setting Supply Options Finding the Supply Options 3-1 Ribbon 3-2 Supply Type Indexed supplies 3-3 Non-indexed supplies Dispense Mode On-demand 3-4 Continuous Continuous Mode Features 3-5 Print Position bottom 3-6 top 3-7 Supply Position 3-8 Margin Position left 3-9 right increase 3-10 left Page Page 4. Setting Communication Values Finding Communication Value Options 4-1 Baud Rate 4-2 Word Length 4-3 Stop Bits 4-4 Parity 4-5 Flow Control 4-6 Reset to Default Values 4-7 4-8 Read This First 5. Setting the Contrast increasing 5-1 decreasing darkens 5-2 lightens 6. Setting Defaults Finding Default Options 6-1 Monetary Sign 6-2 Secondary Sign No 6-3 Yes 6-4 Decimal Places 6-5 Page 7. Printing Online System Administrators Guide 7-1 Equipment Manual 7-2 Index A Index-1 B C R S Index-2 W