Setting the Communication Values
3.Press L or R to display the flow control you need, then press E .
NOTE: The XON character is 17. The XOFF character is 19.
If you have an IBM personal computer, set flow control to DTR (unless you have XON/XOFF software).
You will see
PORT SETTINGS
<Flow Control
4.Press Q to exit to the Setup menu.
5.Press Q to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.
Reset to Default Values
To reset the communication values to the defaults, follow the steps listed under "Finding Communication Value Options." Then follow the steps below.
1.Press R until you see
PORT SETTINGS
<Reset
Values | Setting Communication |
|
|
