Motorola DCT 2000 installation manual Initialization status errors Error Code, Cause Remedy

D i a g n o s t i c s B - 5

Table B-3 lists the error codes:

Table B - 3

Error codes

Initialization status errors
Error Code	OSD	Cause	Remedy
E 00*	NO ERROR	Indicates normal condition after initialization	Not applicable
E 01*	NOT CONNECTED	DCT 2000 did not receive a connect message	Send a connect message
			Restore out-of-band signal
E 02	PWR CYCLE	Init Error	Box needs a Power Cycle to
			recover
E 03	DRAM	DRAM error	Not used at this time
E 04	DPSRAM	DP-SRAM error	Not used at this time
E 07	ROM	ROM verification failure	Power cycle box; if repetitive,
			return for repair
E 08	RAM	Faulty RAM, ROM, EEPROM, or POST failure	Return DCT 2000 for repair
		(this is a hardware failure)

E 09	BATTERY	Dead battery or memory has not been
		initialized; occurs if battery fails to keep the
		RAM alive during power-down; causes
		DCT 2000 to be disconnected

Return DCT 2000 for repair; requires factory initialization message

E 10	SERIALNO	Invalid serial number	Not used at this time
E 11	UNIT ADDRESS	Invalid unit address	Return DCT 2000 for repair;
			requires a unit creation message
E 12	POST	POST failed	Not used at this time
E 13	BOOT	Sys_boot initialization failure	Power cycle box; if repetitive,
			return for repair
E 14	STARTUP	DCT 2000 system startup failure	Power cycle box; if repetitive,
			return for repair
E 15	TSI INVALID	TSI structure is corrupted	Power cycle box; if repetitive,
			return for repair
E 16	FLASH BAD NUMBER	Bad flash number specified for	Error logged, ignore
		InitiateFlashPlatform
E 17	BAD PLATVAL	Bad platform validation step number	Error logged, ignore

*E 00 and E 01 cannot be displayed while the DCT 2000 is off. The other errors will display on the LEDs when the DCT 2000 is off.

DCT 2000 Installation Manual