Callback Security Commands | Multi-Tech Systems MT2834BR, MT2834BLR

	Chapter 4 - Commands


DEFAULT:	n/a
DESCRIPTION:	Causes modem to wait for ringback, then 5 seconds of
	silence before processing next part of command.
COMMAND:	+++AT<CR>
VALUES:	n/a
DEFAULT:	n/a
DESCRIPTION:	In-band Escape Sequence. Places modem in Command
	mode while still remaining On-Line. Enter +++ followed by
	the letters A and T, up to ten command characters, and a
	RETURN.
COMMAND:	BREAK AT<CR>
VALUES:	n/a
DEFAULT:	n/a
DESCRIPTION:	Out-of-band Escape Sequence. Places modem in
	Command mode while still remaining On- Line. Not
	preceded by AT. Enter a BREAK signal, followed by the
	letters A and T, up to sixty command characters, and hit
	RETURN.
COMMAND:	*C <Enter>
VALUES:	0, 1, 2
DEFAULT:	0
DESCRIPTION:	Caller ID Reporting the Call Traffic Window displays the
	phone number and name of the caller (if the caller's phone
	line supports Caller ID). The call must be answered after
	the second ring to receive the information. This feature
	requires a modem hardware upgrade, Caller Id-enabled
	phone lines, and firmware version greater than 8.07a or
	2.07a. The firmware is disabled by default, enabled by the
	*C command.

4.1.1Callback Security Commands

COMMAND:	#DBn
VALUES:	n= 0, 1, or 2
DEFAULT:	DB0
DESCRIPTION:	#DB0 disables Callback Security and answering Yes to the
	prompt turns off Callback Security and erases stored phone
	numbers and passwords. Answering No to the prompt
	aborts the command.
	#DB1 activates remote and local password security.
	#DB2 activates remote password security.
COMMAND:	#CBNyyxxxxxx
VALUES:	n/a