Multi-Tech Systems MT2834BLR, MT2834BR manual Registers, Escape Code Character

Chapter 4 - Commands

4.2S-Registers

Certain Command Mode configurations are stored in memory registers called, S-Registers. The S command is used to assign a value to, and to read the current value of an S-Register.

To assign a value to an S-Register, enter the letter S, followed by the S- Register number and an equals sign (=), and then a decimal response to the message “ENTER THE NEW VALUE IN DECIMAL FORMAT”.

To read an S-Register value, enter the letter S followed by the S-Register number and a question mark (?), then hit RETURN. To verify that the S- Register value was entered correctly, enter for example, ATS8? and hit RETURN. You should receive a response of the assigned value given to that S-Register.

S0

Number of Rings Until Modem Answers

Unit:	1 ring
Range:	0-255
Default:	1
Description:	Sets the number of rings before the modem answers.

S1

Rings Which Have Occurred

Unit:	1 ring
Range:	0-255
Default:	0
Description:	Counts the number of rings that have occurred.

S2

Escape Code Character

Unit:	ASCII Character
Range:	0-127
Default:	43 (+ sign)
Description:	Defines the escape code character.
S3
Return Character
Unit:	ASCII Character
Range:	0-127
Default:	13
Description:	Defines the character recognized as Carriage Return
	(RETURN) or “Enter”.

48