| Chapter 4 - Commands |
|
|
|
|
VALUES: | n = 4 or 5 |
DEFAULT: | &T5 |
DESCRIPTION: | &T4 selects Enable Response to Request for Remote |
| Digital Loopback. |
| &T5 selects Disable Response to Request for Remote |
| Digital Loopback. |
COMMAND: | #Tn |
VALUES: | n = 0 or 1 |
DEFAULT: | #T1 |
DESCRIPTION: | #T0 turns off Trellis Coded Modulation |
| #T1 turns on Trellis Coded Modulation |
COMMAND: | Un |
VALUES: | n = 0, 1, 2, or 3 |
DEFAULT: | n/a |
DESCRIPTION: | U0 places modem in Analog Loop Originate Mode. |
| U1 places modem in Analog Loop Answer Mode. |
| U2 places modem in Remote Digital Loopback test mode. |
| U3 places modem in Local Digital Loopback Test Mode. |
COMMAND: | Vn |
VALUES: | n = 0 or 1 |
DEFAULT: | V1 |
DESCRIPTION: | V0 means Result Codes sent as digits(terse response). |
| V1 means Result Codes sent as words (verbose response). |
COMMAND: | W |
VALUES: | n/a |
DEFAULT: | n/a |
DESCRIPTION: | Wait for new |
COMMAND: | &Wn |
VALUES: | n = 0 or 1 |
DEFAULT: | &W1 |
DESCRIPTION: | &W0 causes modem to store its current parameters in non- |
| volatile RAM, and modem will load these for future |
| sessions instead of reading factory ROM defaults, unless |
| &F command used. |
| &W1 causes modem to not store parameters. |
COMMAND: | Xn |
VALUES: | n = 0, 1, 2, 3 or 4 |
41
