|
|
| The |
Examples | |
NOTES | A port can be a member to several VLANs, but can only have one PVID |
Set Backpressure |
|
Command Name | port set backpressure |
Description | Enables or disables backpressure on a given port. This is normally used on |
| 10Base setups and is a controlled by the hardware. |
Syntax | port set backpressure |
Parameters |
|
| port number (1 ~ 24) |
| enable disable |
| Backpressure enable or disable |
Examples | |
NOTES | Check whether |
Set Intruderstate |
|
Command Name | port set intruderstate |
Description | Enables or Disables the intruder log. |
Syntax | port set intruderstate <enable disable> |
Parameters | enable disable |
| Enable or disable the intruder log |
Examples | |
NOTES | This must be enabled for the intruder log to log anything. |
Set Priority Level |
|
Command Name | port set prioritylevel |
Description | Sets the priority level of a given port. |
Syntax | port set prioritylevel |
Parameters |
|
| port number (1 ~ 26) |
| level |
| priority level (0 ~ 7) |
Examples | |
NOTES | Priority State should be enabled to use this feature. |
Show Configuration |
|
Command Name | port show config |
Description | Displays basic configuration settings on given ports. |
Syntax | port show config |
Parameters |
|
| port number (1 ~ 26), you may enter all to see all the ports at once. |
Examples | |
NOTES | Check whether |
Show Intruders |
|
Command Name | port show intruder |
Description | Displays a list of MAC addresses that were not allowed on the network. |
Syntax | port show intruder |
Parameters | None |
Examples | |
NOTES | Intruder log must be enabled before this will log anything. |
(Revised | page 112 of 145 |