TROUBLESHOOTING
1.Make sure the 
(Power LED) is ON.
2.Make sure you are supplying sufficient current for the version chosen. Note: The Inrush current will exceed the steady state current by ~ 2X.
3.Verify that Link LED‟s are ON for connected ports.
4.Verify cabling used between stations.
5.Verify that cabling is Category 5E or greater for 100Mbit Operation.
SUPPORT
Contact
TEL:
FAX:
FCC STATEMENT
This product complies with Part 15 of the
Operation is subject to the following conditions:
(1)This device may not cause harmful interference
(2)This device must accept any interference received, including interference that may cause undesired operation.
(Revised | page 23 of 145 |
